Graph Paper

A low-voltage lighting system generally consists of a transformer, which is plugged into an outlet on the wall, and the results in 110-volt electricity generated at about 12 volts. Then, the current passes through a low voltage cable for the lighting of the valve on your home appearance. It can be used for the removal of your landscaping, sidewalks and other features in your house exterior, you want to improve, while the night.

Tips to install outdoor lighting

1. Get a sketch of your home and any other aspect in connection with on a graph paper. Each block can graph paper to represent the desired dimension, the measurement can be varied, depending on how big your house is.

2. Select key points, like the areas that you want to make very attractive, like a fountain, a statue, etc. Keep the focus on an object more than 2, and the remaining lighting can be used as accents.

3. Select the brackets and place it on your plan, as the path lights, spots, etc. You can rely on the "Cable /Fixture layout guides for distance, lamps and know more about how the installation of low-Outdoor - lighting.

4. Select where the transformer is to give a ruling. Close all devices and with a graph paper for the calculation of the total length of wire that you need, which would only serve to a maximum of 250W on a length of 12 Gauge cable.

5. Calculate the Grae the transformer by adding all the individual fittings. The house's front would require a transformer of 30W, while a 600W transformer would be necessary on the back. Remember to buy a transformer has more capacity than your duty as you can with other areas of lighting may have slipped from your plan.

6. Slopes of the transformer at least 12 centimeters above the ground. For direct wiring, knockouts are usually provided.

7. Remember that any device was on the ground on the graph paper sites. Then run the cable from each fixture, on the ground. The cables can mulch or other substance, not a lot of money. Recommend some online manuals to know how the installation of low-outdoor lighting.

8. Get the brackets attached by the clearing through the main entrance cable. Then the two cable ends, in and connect it to the socket with wire nuts.

9. Before burying the cable or the security of fixtures, remember that the transformer in the night, and for good effect, the repositioning brackets if necessary. The volt system can be easily separated, and the brackets can be relocated for adjusting the angle with the aim shocks.

10 not have to worry about. The so-can be sliced through with a spade or a trough in the mulch for the operation of the cable. The cable must be forced into the opening spade to avoid damage to the wire.

11. Fixture The assistance must be pressed spade into the opening until the bodies come to rest on the ground. The base can be secured to a deck, fence, etc.

To learn more about low voltage outdoor lighting and outdoor lighting system visit http://www.outdoorlightingsystem.org

Article Source: http://EzineArticles.com/?expert=Neil_Jones